The high-end glider drive made in Germany! Easily and efficiently with the proven cooling system from the F3A competition area.
With a special 6mm output shaft for sail models to accommodate the usual spinner / center piece combinations. It is attached to the motor bulkhead using 4x M3 with a 30mm lock circle.
Technical data:
Power range max. 2200W (typical sailor switch-on times)
No-load current at 8.4V 2.93A
Internal resistance 0.0084 Ohm
Idle speed per volt 2430 rpm
Weight 423g
Outside diameter 43.2 mm
Length 91 mm
Controller recommendation MasterSpin 99
Recom. Timing 0 ° - 5 °
Gear reduction ratio 6.7: 1
Shaft diameter 6 mm (length 22mm)
Measured values??
Propeller
Drive battery
Voltage [V]
Current [A]
Speed ??[RPM]
Power [W]
RFM 17x10
6S
22
77
7670
1694
RFM 17x13
6S
22
93
7520
2046
Scope of delivery:
1 C50-9 L 6.7: 1 Glider Competition motor / gear unit, 1 special gear grease and instructions
Specifiactions
max. power range [W] (max.15 sec.)
2200
Poles
2
Turns
9
Idle current (I0) at 8.4V [A]
2,93
Internal resistance (Ri) [Ohm]
0,0084
Gear reducing
6,7 : 1
Recommended timing [°]
0 - 5
Switching Frequenzy [kHz]
8
Controller recommendation [A] (depending on setup)