|
|
The high quality motor. Suitable for top small and lightweight electrogliders, prefarable for classes F5K, F5L and similar.
The motors are of "capsuled" design. The rotor is placed inside capsule. It brings lots of advantages:
- The input cables exit from the back face. The common problem of placing the cables which exit from face plate (and must not come into contact with rotor) of standard outrunners is unknown.
- The shaft dia was increased to 3,17mm The shaft has central hole.
- The bearings are more robust than those for 3mm shaft. They are located at the ends of capsule. The rigidity of the assembly is increased.
- The face plate dia. is 22mm. The firewall from 25mm dia. can be used.
The motors are of "capsuled" design. The rotor is placed inside capsule. It brings lots of advantages:
- The input cables exit from the back face. The common problem of placing the cables which exit from face plate (and must not come into contact with rotor) of standard outrunners is unknown.
- The shaft dia was increased to 3,17mm The shaft has central hole.
- The bearings are more robust than those for 3mm shaft. They are located at the ends of capsule. The rigidity of the assembly is increased.
- The face plate dia. is 22mm. The firewall from 25mm dia. can be used.
The penalty for these advantages is extra weight of the capsule, which is very low.
Motors drawing
To be added
Specificationas
Case Length | 27 |
mm |
Diameter
|
25 |
mm |
Weight
|
36 |
g |
Stator diameter
|
18 |
mm |
Length of magnets | 10 |
mm |
Shaft Diameter | 3,17 | mm |
Mounting | M2,5/16/16 | mm |
Kv | 1600 |
RPM |
Limit power (15s) | 222 |
W |
Prop for 2S | 9x5, 9x6, 10x6 | |
Prop for 3S | 7x4, 8x4, 8x5 |